[MINC-users] minc-toolkit 0.3.11, Display 1.6 segmentation fault on 3D object

[Mishkin Derakhshan]

Hi,
I ran into this issue at some point as well.
I think DIsplay always expects the first file to be a minc file so
something like this worked for me:
Display anymincfile.mnc file1.obj

On Wed, Aug 1, 2012 at 1:56 PM, George Stoynev <gstoynev at biospective.com> wrote:
> Hi all,
>
> I ran in interesting issue today.
> Following the instructions in
> http://www.bic.mni.mcgill.ca/ServicesSoftware/ServicesSoftwareMincToolKit I
> installed the minc-toolkit 0.3.11, the minc-toolkit-testsuite and the
> bic-mni-models on 64-bit Ubuntu 10.04.
> Then I ran "source /opt/minc/minc-toolkit-config.sh" and successfully
> completed the test run "bash /opt/minc/run_tests.sh TEST".
>
> Then I ran "Display file1.obj", where file1.obj is a 3D-object file and I
> got Segmentation fault. But "Display file2.mnc" works correctly, if
> 2D. "Display
> -version" reports it as 1.6.
> For comparison, I ran "/usr/local/bic/bin/Display file1.obj" and the file
> successfully opened. This version of Display is reported as 1.3 and comes
> from display-1.5.0-1maverick_amd64.deb.
>
> Did anybody else experienced such an issue?
>
> Thank you,
> George Stoynev
> _______________________________________________
> MINC-users at bic.mni.mcgill.ca
> http://www.bic.mni.mcgill.ca/mailman/listinfo/minc-users