[MINC-users] minc-toolkit 0.3.11, Display 1.6 segmentation fault on 3D object

[George Stoynev]

Hi all,

I ran in interesting issue today.
Following the instructions in
http://www.bic.mni.mcgill.ca/ServicesSoftware/ServicesSoftwareMincToolKit I
installed the minc-toolkit 0.3.11, the minc-toolkit-testsuite and the
bic-mni-models on 64-bit Ubuntu 10.04.
Then I ran "source /opt/minc/minc-toolkit-config.sh" and successfully
completed the test run "bash /opt/minc/run_tests.sh TEST".

Then I ran "Display file1.obj", where file1.obj is a 3D-object file and I
got Segmentation fault. But "Display file2.mnc" works correctly, if
2D. "Display
-version" reports it as 1.6.
For comparison, I ran "/usr/local/bic/bin/Display file1.obj" and the file
successfully opened. This version of Display is reported as 1.3 and comes
from display-1.5.0-1maverick_amd64.deb.

Did anybody else experienced such an issue?

Thank you,
George Stoynev