[MINC-users] convert mesh from VTK to .obj

[dfwang@cse.cuhk.edu.hk]

Hi, Simon,

Thanks for your reply. Yes, my VTK mesh is in triangular.

My linux system is CentOS 4.4. I downloaded your small parser just now, and
changed the mode by

chmod a+x parse.bin

then run parse.bin, I got the following error,

Floating point exception

Could you please tell me how I can run it successfully?

Best wishes,
Defeng
Quoting Simon Fristed Eskildsen <se at hst.aau.dk>:

> Hi Defeng,
> 
> If you're dealing with triangular mesh and pure ascii, you can try my 
> small parser found here:
> 32bit linux: http://www.hst.aau.dk/~se/software/parse.bin
> 64bit linux: http://www.hst.aau.dk/~se/software/parse.bin64
> 
> Also, more information about the .obj format can be found here:
> http://wiki.bic.mni.mcgill.ca/index.php/ObjectFiles
> 
> Simon
> 
> Defeng WANG wrote:
> > Dear MINC Users,
> > 
> > I have one mesh in VTK format at hand, and would like to convert it into
> the 
> > .obj format in MINC. Which tool can do this? Or any suggestions on the way 
> > to convert it?
> > 
> > Many thanks!
> > Defeng
> > 
> > 
> > _______________________________________________
> > MINC-users at bic.mni.mcgill.ca
> > http://www.bic.mni.mcgill.ca/mailman/listinfo/minc-users
>