[MINC-users] surface simplification

[francois hebert]

Hi Simon,

I must say I do not know too much about mesh. From my point of view is more
a decimation approach.
It still can be interesting to try an algorithm that remove short edges.

Francois


2010/3/4 Simon Fristed Eskildsen <se at hst.aau.dk>

> Hi Francois,
>
> Do you need an algorithm to simply remove short edges? Or is it rather a
> decimation approach, where the geometrical features are preserved, you are
> after?
> I can probably help you with the former, but not the latter.
>
> Simon
> ----- "francois hebert" <francois.hebert007 at gmail.com> wrote:
>
> > Hi everyone,
> >
> > I would like to simplify (reduce the number of vertex) by means of an
> > edge
> > collapsing algorithm.
> > My surface is a minc obj file so I would like to know if there is a
> > minc
> > program that can perform it?
> >
> >
> > Francois Hebert
> > Research Assistant
> > Small Animal Imaging Laboratory
> > Montreal Neurological Institute
> > McGill University
> > Genome building
> > Rm 3200
> > ph: 514-398-5849
> > _______________________________________________
> > MINC-users at bic.mni.mcgill.ca
> > http://www.bic.mni.mcgill.ca/mailman/listinfo/minc-users
> _______________________________________________
> MINC-users at bic.mni.mcgill.ca
> http://www.bic.mni.mcgill.ca/mailman/listinfo/minc-users
>