[MINC-users] mincresample of negative zsteps

[Roch M. Comeau]

Hi,

I may be wrong (I never fully understood MINC back then, and I usually used to just nod like I understood when Peter explained things so I did not look too dumb), but the thought may have been to support parallel slices that are skewed, so the slice spacing would be different (shorter) than the distance between the same voxel from slice to slice as described in the direction cosines (non-orthogonal coordinate system).

Roch


On 2010-11-02, at 12:23 AM, Andrew Janke wrote:

> I think so ( in this case). Peter oroginally made a distinction
> between the slice and in-plane dimensions for reasons known to him. I
> think a lot of the reason was around slice scaling of image ranges.
> 
> In any case it can sometimes make for some interesting (and at times)
> unexpected results. :(
> 
> 
> a
> 
> On Tue, Nov 2, 2010 at 14:48, Soren Christensen <sorench at gmail.com> wrote:
>> I am not sure where the problem arises (is it that zspace is my slowest
>> varying dim and the -1 you allude to?)
>> 
> _______________________________________________
> MINC-users at bic.mni.mcgill.ca
> http://www.bic.mni.mcgill.ca/mailman/listinfo/minc-users