[MINC-users] How to extract volumes from 4D sets

[Jon Erik Ween]

Hello all

Is mincextract the proper way to get a volume out of a 4D set? I have  
dti images but need to extract the b0 from the rest (the b0 is always  
first). Can't quite figure out what parameters to use for mincextract.

Thanks

Jon

Soli Deo Gloria

Jon Erik Ween, MD, MS
Scientist, Kunin-Lunenfeld Applied Research Unit
Director, Stroke Clinic, Brain Health Clinic, Baycrest Centre
Assistant Professor, Dept. of Medicine, Div. of Neurology
     University of Toronto Faculty of Medicine

Kimel Family Building, 6th Floor, Room 644
Baycrest Centre
3560 Bathurst Street
Toronto, Ontario M6A 2E1
Canada

Phone: 416-785-2500 x3648
Fax: 416-785-2484
Email: jween at klaru-baycrest.on.ca


Confidential: This communication and any attachment(s) may contain  
confidential or privileged information and is intended solely for the  
address(es) or the entity representing the recipient(s). If you have  
received this information in error, you are hereby advised to destroy  
the document and any attachment(s), make no copies of same and inform  
the sender immediately of the error. Any unauthorized use or  
disclosure of this information is strictly prohibited.